The size of the clamp head should be suitable for the thickness of the wire rope. The inner net distance of the U-shaped ring should be 1~3mm larger than the diameter of the wire rope. If the net distance is too large, it is difficult to clamp the rope; when using, the U-shaped bolt should be tightened until the wire rope is pressed. Flat about 1/3. Since the wire rope is deformed after being stressed, the rope should be tightened a second time after the wire rope is stressed to ensure the firmness of the joint. If you need to check whether the rope clip slides after the wire rope is stressed, you can use an additional safety rope clip to carry out. The safety rope clip is installed about 50mm away from the last rope clip. Release the rope end for a safety bend and then clamp it with the main rope. In this way, if the clip slips, the safety bend will be straightened, which is easy to find and reinforce in time.